Skip to content

Cookies 🍪

This site uses cookies that need consent.

Learn more

Zur Powderguide-Startseite Zur Powderguide-Startseite

Language selection

Search PowderGuide

gear of the week

Gear of the Week | G3 Via Carbon Ski Poles

Two-piece telescopic carbon ski pole

by Benjamin Eggert 01/20/2018
The G3 GEAR Via Carbon telescopic ski poles have proven to be loyal companions on several ski tours this season.

When unpacking the ski poles at the start of the season, the new owner had to decide straight away: Which ski pole tips should be fitted to the telescopic poles? The small rounds for hard snow or the large powder plates? Thanks to the brilliant start to the winter, the decision was easier than ever and I naturally went for the large version.

The shape of the plate proved to be helpful when walking and poling on wind-compressed snow, as the triangular shape doesn't tend to get caught in the snow surface when the wind cap breaks through. In powder, the penetration depth of the poles is low and you can put enough pressure on the pole to increase propulsion on the ascent.

The grip loops, which almost look like the loops on cross-country ski poles, are also very helpful here. The size of the strap can be easily adjusted to the size of the wrist or glove. At the end of pole use, the fingers can easily detach from the grip without the risk of losing the ski pole. This extends the stroke movement when using the pole and increases efficiency on the ascent.

In my opinion, it makes no sense to use the straps on the descent. It is even possible to remove the loops from the handle with a simple hand grip. But then don't forget to stow them in your backpack or somewhere else! Otherwise you will miss the loops on the next tour or climb.

gear of the week
presented by

Another helpful detail is on the handle of the pole. While the deeper the snow, the better on the descent, a lot of fresh snow can make us despair on the ascent. This is when the snow sticks to the surface of the ski and significantly increases the weight of the ski. Only thick thighs and a horse's lung can help. Or you can try to free the ski from the snow. Sometimes this is not so easy, as it is already icy. Then the only thing that helps is to take the handle of the ski pole and scrape off the snow. A small nose has been attached to the handle of the Via Carbon for this purpose. This makes it easy to remove the snow from the ski without having to get out of the binding.

This nose is also helpful when closing the lever of a pin binding in ascent mode. The lever can be closed comfortably from a standing position and it is no longer necessary to bend your back. Another detail are the eyelets on the handle. Cords can be attached here, for example to secure a tent against the wind or to build a washing line.

Other than that, the handle feels very stable and comfortable. Unfortunately, this is also noticeable in the weight. For downhillers, this is irrelevant - but for the speed tourers among us freeriders, it may be decisive.

Those who are strongly oriented towards ascents may also miss a grip tape or a foam wrap underneath the grip. For long traverses, the pole can be gripped shorter, which makes traversing more comfortable. The Via Carbon has a plastic ring one grip length below the handle. The pole can also be gripped quite well here, but the grip is not comparable with a foam surround.

The tip of the ski pole fits into the inserts of pin-binding compatible ski boots like a lid on a pot. Icy inserts can be easily de-iced with the ski pole tip.

The mechanism for changing the length of the pole makes a very good impression. The lever closes reliably and can be operated with little effort. The length can be adjusted from 115 cm to 145 cm. The length can be reduced by a further 20 cm to attach the poles to the backpack.

Conclusion

The G3 Via Carbon makes a very solid and high-quality impression. The pole scores points with many details on the handle. However, it is also the handle that makes the pole appear somewhat heavier. Depending on the intended use, the extra weight is of course justified due to the greater comfort and utility. In my opinion, a rubber coating underneath the handle is recommended for more grip on the short pole handle. This can of course be retrofitted without any problems.

This article has been automatically translated by DeepL with subsequent editing. If you notice any spelling or grammatical errors or if the translation has lost its meaning, please write an e-mail to the editors.

Show original (German)

Related articles

Comments

gear of the week
presented by